And better than ever!
New Project
Ka-Bar/Becker BK-2 "Campanion" Knife
I removed the Abrasive black coating on the blade, using "Klean-rite" paint stripper
2. Put a "convex" edge on the blade. This makes it a sturdier "chopper"
Sharpening
As a side note, I took the knife to Ithaca and Keith and I put it to the test, chopping and splitting wood. It worked very well!
3. Picked up some Ash from
Woodcraft to make new scales
Cut out a rough blank with my scroll saw
And hand carved with my new Mora
Next I polished the blade until it was almost mirror bright, but it kept rusting on me, so I did a little research and came up with "forced patinas".
I soaked the blade in a vinegar damp rag for a few hours and the mottled the blade by smearing it with ketchup, letting it sit for 1/2 hour.
Cleaned with soap and water, and a quick rub with #0000 steel wool and this is the end result.
Just about done. Handle still needs sealed.
So, Whadda ya think? Not bad for a novice!